|
|
| Line 1: |
Line 1: |
| | {{Template:C9Header|EMV Terminal/Pin Pad Setup}} | | {{Template:C9Header|EMV Terminal/Pin Pad Setup}} |
| | | | |
| − | =How add Certificate to Tetra= | + | =Ingenico Tetra IP & PDC Setup= |
| − | For instance, if we are adding '''Lane 3000'''
| + | [[https://c9pg.com/docs/PaymentDevices/Ingenico/Tetra/IngenicoTerminalSetup.pdf Ingenico IP Setup]] |
| − | <pre>
| |
| − | Here are the steps to configure the device:
| |
| − | 1.Press 2-6-3-4-F
| |
| − | 2.Enter TDA->Configuration
| |
| − | 3.Communication->Select Comm. Type->Ethernet->Press Green key( OK )
| |
| − | 4.Communication->Ethernet Settings->Connection Method->Client->Press Green key( OK )
| |
| − | 5.Communication->Ethernet Settings->HostIP Address->34.213.177.219->Press Green key( OK )
| |
| − | 6.Communication->Ethernet Settings->IP Port->12009->Press Green key( OK )
| |
| − | 7.Communication->Ethernet Settings->SSL->None->Press Green key( OK )
| |
| − | 8.Pressing RED(X-Cancel) key will return to previous menu...press it until it will prompt "Save and Reboot?"-> Choose Yes->Press Green key( OK )
| |
| − | Device will reboot...Enter "This lane closed"...leave it for a few seconds and it will start to download configuration and then it will reboot by itself
| |
| − | | |
| − | May need to add Attachment to C9pg folder on the workstation profile
| |
| − | certificate\PinPad\client\CLIENT_CERT.PEM
| |
| − | | |
| − | There should be a distinct setup for Tetra make sure to check profile PDC/CONF com.jijesoft.gateway.pinpadNameList.ini
| |
| − | [DeviceOnDemand]
| |
| − | IWL258=true
| |
| − | L5000=true
| |
| − | L3000=true
| |
| − | IF you dont see the L3000=true then add it in there same as above.
| |
| − | | |
| − | They should be running PDC 2.01.07 for this function to work.
| |
| − | After the above open the PDC on the user profile and enter the IP of the device then test the PDC. You should be able to run a transaction on the terminal and see it on cloud9.
| |
| − | </pre>
| |
